18 m floating cable, 2-core, for Dolphin pool cleaner

The 99958903-DIY cable for Dolphin pool cleaners has a total length of 18 m and a diameter of 10 mm.

This cable has two wires, making it incompatible with pool cleaners that have functions such as a dirty-filter warning, remote control, or cycle selection. If this two-wire cable is installed on such models, those functions will be disabled.

It is equipped with a motor connector.

This cable is not equipped with the Swivel cable anti-twist system, which prevents the cable from tangling around itself, thus avoiding forced operation of the pool cleaner and ensuring its ability to access the entire pool without obstacles.

Please note that not all Dolphin pool cleaners use the same type of cable.

As a general rule, if the cable enters the pool cleaner through the top, you will need a cable whose reference ends in -DIY. These cables come with the motor connector already installed; the opening in the cleaner housing is large enough for the connector to pass through.

If the cable is installed through the side of the pool cleaner, you will need one whose reference ends in -ASSY. These cables have the end without the motor connector, only the wires, and you will need an adapter kit to connect it to the motor. Generally, the opening in the cleaner housing is too small for the cable to pass through with the connector installed on the end; therefore, you must first pass the cable through the opening and then install the motor connector.

Valid for the following automatic pool cleaners:atic: