DOLPHIN POOLSTYLE SERIES

The Dolphin Poolstyle Series is compatible with in-ground and rigid above-ground pools up to 10 or 12 meters long, depending on the model selected. It works on PVC liner, painted concrete, polyester, and glazed tile surfaces thanks to its continuous-track drive.

To ensure optimal movement on floors with steep slopes or diving pits, it's advisable to check that the water's chemical parameters are balanced. You can monitor these levels using a Scuba II Pool Photometer to prevent slippery algae from forming.

Post-cycle maintenance involves removing the Easy-Clean filter basket through the top hatch and rinsing it with a low-pressure hose. This takes less than three minutes and prevents sediment buildup that could overload the suction motor.

• Remove the equipment by pulling the ergonomic handle until the water drains through the quick-release valve.
• Open the top cover without needing to turn the robot upside down on the pavement.
• Clean the filter panels with running water before the dirt dries.
• Store the equipment in a shaded place away from direct sunlight.

The main difference lies in energy independence and mechanical dirt-retention efficiency. While a hydraulic pool cleaner depends on the filtration pump's power and saturates the main filter's sand, Dolphin Poolstyle Series electric cleaners operate with their own internal 24V motor and retain debris in their own basket.

In addition, the Dolphin Poolstyle Series features an active brush that rotates at twice the robot's forward speed to remove algae from the surface. Basic suction hydraulic models lack active brushing and only suction up loose debris from the pool floor.

Dolphin Poolstyle Series robots convert the 230V AC from a household outlet to 24V DC using a waterproof power supply with double safety insulation. This conversion ensures operation at very low contact voltage inside the pool.

To complement the comprehensive protection of outdoor facilities and residential pool areas, you can add approved accessories such as the Aqualarm pool alarm to your aquatic environment. Always keep the transformer at least 3.5 meters from the water’s edge during the cleaning cycle.

The default operating cycle in the Poolstyle Series lasts a standard two hours per session. During this timed interval, the CleverClean smart scanning software maps systematic routes through the pool to ensure 100% coverage of the programmed surface.

Average electricity consumption during this cycle does not exceed 150 watts per hour, representing significantly lower energy consumption than running a traditional 1 HP filtration pump for four hours of manual cleaning.

Mid-range and advanced Dolphin Poolstyle Series models climb walls and sweep the waterline thanks to their multidirectional discharge flow and grippy tracks. Entry-level models are calibrated exclusively for floor cleaning.

• Basic models: focus 100% of the cycle on the pool floor and lower cove.
• Top models: climb vertical tile, fiberglass, or liner walls, scrubbing the waterline.
• Adhesion effectiveness: guaranteed as long as chlorine and pH levels prevent the formation of slimy algae.

The standard filter basket traps medium and coarse debris such as leaves and insects, while the ultrafine filter panels capture microscopic particles as small as 50 microns. This dual capability prevents suspended dust from returning to the pool water while the pool cleaner is running.

If your pool is exposed to persistent fine dust from muddy rain or nearby dirt areas, it’s a good idea to alternate between standard mesh panels and fine-filtration cartridges depending on seasonal conditions in 2026.