LumiPlus Motion Wireless AstralPool Remote Control

The LumPlus control motion remote control will allow you to directly select on/off using buttons, you can also select the change of 12 colors and 8 sequences as well as the sequence speed.

It incorporates an accelerometer sensor, thus allowing colors and sequences to be activated through movement.

The remote control is only compatible with the LumiPlus Wireless product range.

Programming

Note: Before starting to program the remote control, make sure that the projector is not powered.

1. Connect the projector to the network then turn on the remote control (you have one minute to finish the process or you will have to start over).
2. Press and hold the refresh key on the remote control for 15 seconds, until number 1 on the remote control lights up (or the channel you have configured from 1 to 4).

2.1 Stop pressing the refresh key.

2.2 Press + or - to change channels (it has 4 different channels)

2.3 Press the refresh key again to save the channel.

2.4 Check that the projector responds to the commands of the remote control.

If point 2.4 is met then you will have successfully changed the new channel. If the lamp does not respond, start again from point 1.