Floating cable 30 m with swivel, 3 wires, for Dolphin pool cleaners

The 99955747-DIY cable for Dolphin pool cleaners has a total length of 30 m.

This cable has three wires, making it suitable for pool cleaners equipped with a dirty filter warning, remote control or cycle selection. If you installed a two-wire cable in these pool cleaners you would lose these functions.

Equipped with motor connector.

It incorporates the Swivel cable anti-twist system, which prevents the cable from tangling on itself, thus avoiding forced operation of the pool cleaner and guaranteeing its ability to access the entire pool without obstacles.

Please note that not all Dolphin pool cleaners have the same type of cable.

As a general rule, if the cable entry to the pool cleaner is from the top you will need a cable whose part number ends in -DIY. These cables come with the motor connector already installed, the opening in the vacuum housing is large enough to fit the connector through.

If the cable is installed on the side of the pool cleaner, you will need one whose part number ends in -ASSY. These cables have the end without the motor connector, just with the cables and you will need an adaptation kit to connect it to the motor. Generally the opening in the vacuum cleaner housing is too small for the cable to pass through with the connector installed on the end; Therefore, you must first pass the cable through the opening and then install the motor connector.

Replacement of the 30 meter ASSY AYN swivel cable for the Dolphin Pro X2 Pool Cleaner. Reference: 9995747LF-ASSY.

The image shown of the item may not match the actual image of the item offered for sale.