CTX-1596 PhosFree phosphate remover, 1 L.

CTX-1596 PhosFree phosphate remover is specially formulated to remove excess phosphates from swimming pool water.

It can remove phosphates originating from chemicals, fertilizers, cleaning products, and other contaminants.

It is also fully compatible with most common disinfection treatments used in swimming pools.

The use of this product has been shown to significantly improve the performance of salt chlorination equipment.

DIRECTIONS FOR USE:

• Hold the bottle upside down so that the dosing chamber can fill.
• Unscrew the bottle cap.
• Empty the dosing chamber.
• For a specific volume, tilt the bottle and determine the desired dose.

DOSAGE:

• Initial treatment for pools with high phosphate levels:

• Test the phosphate level of the pool water using a phosphate test kit.
• Clean the filter.
• Calculate the required amount of product, pouring the dose directly into the pool and distributing it over the surface.
• Keep the filtration system running for at least 24 hours. (If the filter pressure increases noticeably, clean the filter.
• After 48 hours, test the phosphate level in the water again. Repeat the treatment if necessary.

Using PhosFree may cause the pool water to become cloudy during the initial phase. This is normal and indicates that the product is working correctly; the cloudiness will disappear within a few minutes.

• Maintenance treatment:

• With the filtration system running, add 60 ml of product per 50 m³ of water each week to maintain phosphate levels below 125 ppb.
• This dosage is for guidance only and may be adjusted according to the specific characteristics of each pool, weather conditions, etc.